Home > News > Content

Steel Silo Roll Forming Machine Cold Forming Machine Industry Prospects

Steel Silo Roll Forming Machine Cold Forming Machine Industry Prospects

Cold Forming Machine Industry Prospects

In China, since the late 1950s began to build a cold bending unit, has undergone the development and adjustment of the twists and turns process, the late 70s only 6, 80's China's cold-formed steel rapid development, to only 16,000 tons in 1982 production, To 1989, the country more than 20 manufacturers, production development to more than 30 million tons, the design capacity of more than 60 million tons, of which 14 key metallurgical system plant, 45 sets of units, cold-formed steel specifications are also increasing, Has reached more than 800 species.

In the favorable form of reform and opening up, the national economic construction of steel varieties and quality of the new requirements, the advantages of cold-formed steel gradually recognized and accepted, cold-formed steel equipment production has made great progress. So far has more than 100 sets of cold bending units, the annual production capacity of 1.5 million tons, a total of more than 1,000 varieties of specifications.

 In the past has been a drawback is the work must be shut down, and some manufacturers still use grinding wheel cutting machine. Dust and noise are relatively large, incision is not beautiful. Cold-cutting industry, the latest technology, online cutting online sawing, the biggest bright spot can be cut without cutting the workpiece.

Can be without personnel care, automatic operation. Industry upgrades, essential. Cold forming machine is widely used in various fields of the national economy, through the mold will galvanized sheet and other materials extrusion molding, keel machine, shelf machine, deduction board machine and so on. Wide range of applications.

Conventional molding are required to cut off, most of the relatively thin, such as: the door frame pressure buckle buckle are used hydraulic knife thrust, or the use of cutting machine cut

With the continuous development of China's industry, cold-formed technology has also been rapid development. Cold bending machinery and equipment become a professional factory indispensable machinery. Then the use of cold bending machinery and equipment also need to pay attention to the place.

First of all to choose the flat table, a steady machine, you can pull the chassis feet to facilitate the observation of the machine panel. Insert the plug on the hand-held head into the socket on the panel and tighten it, notice the notch.

Then plug the end of the power cord into the socket on the rear panel of the chassis and the other end into the power supply socket. Be sure to use single-phase three-wire power supply. And then open the power switch (POWER SW.) On the rear panel of the chassis. Press the "SWITCHING" button on the panel, and the machine will be able to work with the "WARM UP" green light. Press and hold the "SETTING BUTTON" button to set the appropriate value, usually between 0.5 and 2.0 seconds.

Press the start button on the handle, then the "HEATING" red indicator light, that is heating, the sensor head do not remove, "HEATING" red light off And then remove the sensor head.

Finally, the "WARM UP" green indicator light or the buzzer in the machine shorts the "beep" prompt and the next container can be closed. Check the sealing quality, according to different materials, diameter containers and production efficiency, appropriate dressing "SET button (SETTING BUTTON) button, making the best sealing quality.